Q70 High Precision Current Sensor High Accuracy Oscilloscope Measuring Clamp On Current Probe
Q70 as a wide measuring range current probe has high precision. The model Q70 oscilloscope measuring clamp on current probe, it is suitable for 0-1000A current measurement, both cable and copper bus bar online measurement.
Applications
1. Electric energy meter calibrator (on site)
2. Double clamp type ground resistance tester
3. Double clamp type phase volt-ampere meter
4. Digital multi-meter
5. Multi-function energy meter
6. Oscilloscope
7. Power quality analyzer
8. Matched instruments
9. Calibration instrument on site
Features
1. Measurement range of 1mA to 1000A AC
2. Small, compact size
3. Improved ergonomic design and easy operation
4. Low phase shift for power measurement
5. With load capacity ≤4Ω; When 1A output, it is 0.1Ω; When 5A output, it is 2.5VA.
6. Output model: Lead output(2.5m)
PARAMETERS
| Electrical parameters |
| Ratio |
1000: 1 or 2000:1 (customized) |
| Accuracy class |
0.2%, 0.5%, 1% |
| Primary current |
0 - 1000A AC |
| Secondary current |
0 - 5A AC (customized) |
| Max. Cont. Input current |
1200A |
| Over voltage category |
CAT III 600V |
| Output signal (AC current) |
500mA,1A,5A AC at nominal input current |
| Output signal (AC voltage) |
500mV,1V,5V AC at nominal input current |
| Frequency range |
40Hz-2000Hz |
| Dielectric strength |
3KV 50Hz/60Hz at 1 minute |
| Temperature range |
-20°C to +55°C |
| Output |
2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors |
600 V |
| Standard |
EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation |
Clamp type |
| Output mode |
Lead output(2.5m) |
| Mechanical parameters |
| Dimensions (L x W x H) (mm) |
122 x 275 x 35.5 |
| Weight (g) |
720 |
| Holding wire diameter (mm) |
φ60 x 70 |
| Max. jaw opening (mm) |
60 |
| Jaw Color |
White |
| Material |
PC+ABS+Polycarbonate, UL94 V0 |
